Hw 130 Motor Control Shield For Arduino Datasheet Better !!exclusive!! «Cross-Platform Complete»

HW-130 motor control shield

The for Arduino is a widely used, budget-friendly motor driver based on the classic L293D chipset . Often referred to as a clone of the original Adafruit Motor Shield (v1), it is designed to stack directly onto an Arduino Uno or Mega, providing a compact solution for driving multiple motors without messy breadboard wiring. Key Technical Specifications

The outputs are labeled M1, M2, M3, M4.

Power Requirements: The Hidden Trap

The shield breaks out two headers specifically for servos. These bypass the motor driver chips entirely. hw 130 motor control shield for arduino datasheet better

digitalWrite(IN3, HIGH); digitalWrite(IN4, LOW); analogWrite(ENB, 150); HW-130 motor control shield The for Arduino is

• Initialize direction pins as outputs, write HIGH/LOW for direction.
• Use analogWrite(PWM_PIN, value) for speed (0–255).
• Optionally monitor FAULT pin with digitalRead and stop motors on fault.