Bosch Serie 6 Service Mode Portable -

To access the Service Mode (also known as test mode or diagnostic mode) on a Bosch Serie 6 washing machine, follow the standard "key dance" sequence to view error codes or run component tests. How to Enter Service Mode Preparation

1. Enter Service Mode as described in Part 2.
2. Navigate to Test Code 99 (varies by software version, sometimes 88 or 00).
3. Press and hold "Start/Reload" for 10 seconds.
4. The display will flash "End" or "FAb" (Factory adjustment block).
5. Immediately after reset, you must run a calibration:

Quick

Use the or Button B to cycle through the modes (P1, P2, etc.). P0 usually displays error codes (C0-C7 memory slots). P2 illuminates all LEDs to check for display faults. bosch serie 6 service mode

If you found an error like "F:16" (motor tacho fault) but the motor works fine in service mode (Test 04), you likely have a logic ghost. Service Mode allows a full reset. To access the Service Mode (also known as

2. Architecture and Key Components

11

If you select Code (Fault memory), the machine will cycle through stored errors. A typical error code might look like "E:30" (pump blocked) or "E:18" (heater relay stuck). Write these down before turning the machine off. Enter Service Mode as described in Part 2

• Check Error Logs: Rotate the knob to different positions to view the last stored error codes.
• Component Testing: You can manually activate the water valves, drain pump, and heater by pressing the function buttons.
• Resetting: Often, simply entering and exiting this mode can clear minor sensor glitches.