Arduino Sensor Shield V5 0 Manual Extra: Quality

Arduino Sensor Shield V5.0

The is an expansion board designed to simplify the connection of multiple sensors, servos, and communication modules to an Arduino Uno or Mega. By organizing I/O pins into standardized 3-pin headers (Signal, VCC, Ground), it eliminates the need for breadboards and complex wiring. Key Specifications & Features

The Arduino Sensor Shield V5.0 addresses this challenge by expanding the microcontroller's I/O pins into a standardized "GVS" (Ground-Voltage-Signal) interface. This manual outlines the operational parameters of the shield, detailing its power management systems and I/O mapping to facilitate efficient project development. arduino sensor shield v5 0 manual

void setup() myServo.attach(servoPin);

Q3: Does it support 3.3V sensors?

No, the VCC pins provide 5V. For 3.3V sensors, you must use a level shifter or a separate 3.3V supply. Arduino Sensor Shield V5

• PCB Dimensions: 53mm x 53mm (Standard Arduino Shield dimensions).
• Weight: Approx. 20g.
• Operating Voltage: 5V (Logic level).
• Input Voltage (Recommended): 6.5V ~ 12V (External power input via screw terminal).
• Max Current Handling: The shield utilizes a high-current driver chip (typically L293D or similar logic) allowing for robust servo driving capabilities.
• Interfaces:

  Q: Does this work with Arduino Mega 2560?

  A: Partially. The first 14 digital pins and first 6 analog pins line up, but the rest of the Mega’s pins will hang off the edge. You can use it, but you lose pins D14-D53. PCB Dimensions: 53mm x 53mm (Standard Arduino Shield

  Each digital and analog pin is arranged in a vertical stack: G (Ground) S (Signal)